 |
 |
 |
|
|
|
[Sponsors] | ||||
August 18, 2009, 07:09
|
Heat transfer @ wall boundary
|
#1 |
|
New Member
Alessandro
Join Date: Aug 2009
Posts: 2
Rep Power: 0  |
my doubt is about heat transfer of a particle that sticks on a adiabatic wall.
When it sticks, the tracing of it stop, and the heat transfer how work?... the heat transfer continue till the end of simulation (max integration limit), the evaporation when it is activated continue and a particle can diffuse into a continuous phase or not? thanks a lot |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Heat Transfer using Wall Functions | Tristan | CFX | 0 | May 12, 2009 22:01 |
| Concentric tube heat exchanger (Air-Water) | Young | CFX | 5 | October 7, 2008 00:17 |
| Natural convection - Inlet boundary condition | max91 | CFX | 1 | July 29, 2008 21:28 |
| Heat transfer at wall trap b.c. for DPM? | Henrik Ström | FLUENT | 1 | October 5, 2005 13:22 |
| adiabatic wall boundary of conjugate heat transfer | tomosada | Siemens | 1 | May 13, 2005 01:14 |
Linear Mode
