Boundary conditions in HYPERMESH

tongnan · July 24, 2009, 13:37

I have got a 3d-mesh created by HYPERMESH. I need to give inlet, outlet and wall boundary conditions. Can anyone help me as how do i give these Bc's in HYPERMESH.

thank you very much in advance

ghorrocks · July 25, 2009, 08:10

Isn't this a question you should ask a Hypermesh forum? There's only CFX people here.

Glenn Horrocks

tongnan · July 25, 2009, 09:04

thank you for your reply. I´d like to export the mesh in ANSYS-CFX v11. Therefore, i think anyone knows this question.

In addition, do you know the addresse of the hypermesh forum? Can you tell me? thank you.

ghorrocks · July 26, 2009, 08:52

Hi,

No idea on a Hypermesh forum. But your question sounds a pretty basic one and should be covered by a tutorial example or basic training.

Glenn Horrocks

July 24, 2009, 13:37	Boundary conditions in HYPERMESH	#1
tongnan New Member thomasesel Join Date: Jul 2009 Posts: 13 Rep Power: 17	I have got a 3d-mesh created by HYPERMESH. I need to give inlet, outlet and wall boundary conditions. Can anyone help me as how do i give these Bc's in HYPERMESH. thank you very much in advance

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Impinging Jet Boundary Conditions	Anindya	Main CFD Forum	25	February 27, 2016 13:58
symmetry boundary conditions in cfx	lost.identity	CFX	41	May 22, 2013 08:21
Problems with boundary conditions for a lowRekOmegaSST turbulence model	cfdmarkus	OpenFOAM Running, Solving & CFD	16	November 14, 2011 05:44
Pressure boundary conditions	Lionel S.	Main CFD Forum	1	August 24, 2007 19:03
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues	michele	OpenFOAM Meshing & Mesh Conversion	2	July 15, 2005 05:15

July 25, 2009, 08:10		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,850 Rep Power: 144	Isn't this a question you should ask a Hypermesh forum? There's only CFX people here. Glenn Horrocks

July 25, 2009, 09:04		#3
tongnan New Member thomasesel Join Date: Jul 2009 Posts: 13 Rep Power: 17	thank you for your reply. I´d like to export the mesh in ANSYS-CFX v11. Therefore, i think anyone knows this question. In addition, do you know the addresse of the hypermesh forum? Can you tell me? thank you.

July 26, 2009, 08:52		#4
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,850 Rep Power: 144	Hi, No idea on a Hypermesh forum. But your question sounds a pretty basic one and should be covered by a tutorial example or basic training. Glenn Horrocks