 |
 |
 |
|
|
|
[Sponsors] | ||||
May 13, 2009, 09:13
|
Inflow turbulence problem
|
#1 |
|
New Member
liuzhe
Join Date: May 2009
Posts: 3
Rep Power: 17  |
Hi
I use user fortran to generate random inflow boundary, i set some monitor points in the domain, when i finish the simualtion, i found only the streamwise veloicty component agree with the target data, for the other two velocity components (v and w) the value is samller than the target, and the PSD value of Velocity component of these two components also can not agree with the target spectrum, that mean these two velocity components are damped out when doing the simulation, who can tell the reason, thanks a lot |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Question on Turbulence Intensity | Eric | FLUENT | 1 | March 7, 2012 05:30 |
| Analyze Turbulence | Camilo Costa | CFX | 7 | December 4, 2006 12:00 |
| Spray problem turbulence intensity | chris1980 | OpenFOAM Running, Solving & CFD | 0 | July 7, 2006 02:08 |
| Problem with LaunderSharma compressible turbulence model wrong formulation | luca | OpenFOAM Running, Solving & CFD | 4 | July 3, 2006 07:24 |
| Wall turbulence, viscosity, boundary layer | Patrick Godon | Main CFD Forum | 1 | November 5, 2003 16:39 |
Linear Mode
