Memory error

December 31, 2008, 06:26

Hi all,

This is the error I get

************************************************** **********

solver-pvm.exe - Application error

The instruction at "0x039a178f" referenced memory at "0x1af7ca38". The memory could not be "read"

************************************************** **********

Any suggestions?

Regards, VSB

January 2, 2009, 05:43

I guess you made some mistakes on boundary conditions.

January 5, 2009, 06:31

Hi,

whiz is right - it probably means you are incorrectly calling a CEL expression or giving a incorrect CCL value. Have a close look at the CCL you have written. Check it by running it through CFX-Pre.

Glenn Horrocks

December 31, 2008, 06:26	Memory error	#1
VSB Guest Posts: n/a	Hi all, This is the error I get ************************************************ ****** solver-pvm.exe - Application error The instruction at "0x039a178f" referenced memory at "0x1af7ca38". The memory could not be "read" ********************************************** ******** Any suggestions? Regards, VSB

January 2, 2009, 05:43	Re: Memory error	#2
whiz Guest Posts: n/a	I guess you made some mistakes on boundary conditions.

January 5, 2009, 06:31	Re: Memory error	#3
Glenn Horrocks Guest Posts: n/a	Hi, whiz is right - it probably means you are incorrectly calling a CEL expression or giving a incorrect CCL value. Have a close look at the CCL you have written. Check it by running it through CFX-Pre. Glenn Horrocks

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Compile calcMassFlowC	aurore	OpenFOAM Programming & Development	13	March 23, 2018 08:43
UDF: DEFINE_CG_MOTION for vertical jump motion of an electrode!	alban	Fluent UDF and Scheme Programming	2	June 8, 2010 19:54
OF 1.6 \| Ubuntu 9.10 (64bit) \| GLIBCXX_3.4.11 not found	piprus	OpenFOAM Installation	22	February 25, 2010 14:43
attach/detach (valve opening/closing)	phsieh2005	OpenFOAM Running, Solving & CFD	2	March 21, 2009 06:18
user defined function	cfduser	CFX	0	April 29, 2006 11:58