 |
 |
 |
|
|
|
[Sponsors] | ||||
December 17, 2008, 07:26
|
Output tot. press. each iteration
|
#1 |
|
Guest
Posts: n/a
|
Hello All,
Could anyone advise how to output the value of total pressure on my outlet for each iteration in order to evaluate convergence? I'm looking at the monitors tab in pre but can't see a way of doing it. Thanks, Ianto |
|
|
||
|
December 17, 2008, 07:38
|
Re: Output tot. press. each iteration
|
#2 |
|
Guest
Posts: n/a
|
You have to change the option-field to "expression". Then you can enter a CEL-expression for the total pressure at your outlet, eg. massFlowAve(Total Pressure)@Outlet.
|
|
|
|
||
|
December 17, 2008, 07:55
|
Re: Output tot. press. each iteration
|
#3 |
|
Guest
Posts: n/a
|
Thanks Timon!
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] snappyHexMesh aborting | Tobi | OpenFOAM Meshing & Mesh Conversion | 0 | November 10, 2010 04:23 |
| lift and drag on ship superstructures | vaina74 | OpenFOAM Running, Solving & CFD | 3 | June 8, 2010 13:30 |
| Parallel runs slower with MTU=9000 than MTU=1500 | Javier Larrondo | FLUENT | 0 | October 28, 2007 23:30 |
| [Other] Output Format of MetaMesh | t42 | OpenFOAM Meshing & Mesh Conversion | 0 | August 3, 2007 05:28 |
| Heat exchanger problem | chiseung | FLUENT | 16 | October 20, 2001 05:36 |
Linear Mode
