 |
 |
 |
|
|
|
[Sponsors] | ||||
November 24, 2008, 00:55
|
properties
|
#1 |
|
Guest
Posts: n/a
|
hi,everybody when I set up a multiphase flow,I used the "wet steam" steam5vl from IF97 and water1 as my working fluid, but the software manifests that "The Molar Mass needs to be set for multicomponent cases",how could I do? Is there anyone who can help me? Thankyou verymuch.
|
|
|
||
|
November 24, 2008, 09:28
|
Re: properties
|
#2 |
|
Guest
Posts: n/a
|
Molar weight water (H2O) = 18.01528 g/mol
No need to thank me: http://en.wikipedia.org/wiki/Water_(molecule)#Physics_and_chemistry_of_water Put the value under tab 'molar weight' |
|
|
|
||
|
November 25, 2008, 00:17
|
Re: properties
|
#3 |
|
Guest
Posts: n/a
|
should run fine in the solver. IAPWS defines this when running in the solver. The error is in the GUI only.
|
|
|
|
||
|
November 26, 2008, 03:52
|
Re: properties
|
#4 |
|
Guest
Posts: n/a
|
Thanks a lot.There is another question:the solver may not run when there is error in the GUI, how to do then?
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 06:21 |
| Chemical properties that are used in Fluent | kimej | FLUENT | 4 | August 19, 2011 12:29 |
| Constant velocity of the material | Sas | CFX | 15 | July 13, 2010 09:56 |
| Properties of air versus temperature AND pressure | Vincent | Main CFD Forum | 5 | July 28, 2008 07:28 |
| Two-Phase Buoyant Flow Issue | Miguel Baritto | CFX | 4 | August 31, 2006 13:02 |
Linear Mode
