Axisymmetric Modelling using 2D extrusion -- CFD Online Discussion Forums

November 12, 2008, 13:05	Axisymmetric Modelling using 2D extrusion	#1
Steve Guest Posts: n/a	I'm having some problems with the quality of my mesh when using a partially extruded mesh (rotated). At at the axis where my mesh is revoled aroun, I am experiencin very bad mesh orthogonality, which is affecting my solutions Is there something i can do to counter this geometrically or in CFX-mesh? Advance thanks Steve

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Advice on multi-phase flow modelling	Martin	Main CFD Forum	3	October 14, 2008 06:16
Axisymmetric extrusion	Corentin	Siemens	4	December 14, 2007 12:53
Axisymmetric Mesh extrusion (2d-3d cylinder)	ben akih	CFX	0	August 21, 2006 20:03
axisymmetric annulus modelling	shashikant	FLUENT	3	June 28, 2006 08:53
2-D Compressible Axisymmetric modelling	jehazneb	FLUENT	0	December 20, 2004 06:12

All times are GMT -4. The time now is 11:14.