Automatic Wall Treatment

October 2, 2008, 07:01

Hi,

I have a question concerning the automatic wall function. I read that this model blend omega and u_tau at the wall and set k to zero. I wonder, how one treats the kinetic energy production at the wall!? And I am not sure, how one would do the implementation approach for the u_tau condition. I think one would adjust the viscosity at the wall, but I am not sure, how to set!?

The scalable wall function is just usefull for high-Re models, when using small y+ values, isn't?

Would be nice, if you have any suggestion or articles for my questions! Thanks! Fab

October 5, 2008, 10:06

Hi, me again...

was the question too stupid or does no one have any idea!?

Fab

October 2, 2008, 07:01	Automatic Wall Treatment	#1
Fab Guest Posts: n/a	Hi, I have a question concerning the automatic wall function. I read that this model blend omega and u_tau at the wall and set k to zero. I wonder, how one treats the kinetic energy production at the wall!? And I am not sure, how one would do the implementation approach for the u_tau condition. I think one would adjust the viscosity at the wall, but I am not sure, how to set!? The scalable wall function is just usefull for high-Re models, when using small y+ values, isn't? Would be nice, if you have any suggestion or articles for my questions! Thanks! Fab

October 5, 2008, 10:06	Re: Automatic Wall Treatment	#2
Fab Guest Posts: n/a	Hi, me again... was the question too stupid or does no one have any idea!? Fab

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Commercial meshers] tmerge utility creates unwanted interface/walls comes in the final mesh	Shoonya	OpenFOAM Meshing & Mesh Conversion	11	January 20, 2012 07:23
Wall functions for near wall treatment : k - epsilon model	fivos	Main CFD Forum	4	April 27, 2011 08:44
LES near wall treatment	Valerio	FLUENT	0	April 23, 2008 08:22
Near wall treatment for k-e model	raik	Main CFD Forum	3	May 6, 2007 08:51
Enhanced Wall Treatment?	Marius	FLUENT	0	January 5, 2006 06:25