 |
 |
 |
|
|
|
[Sponsors] | ||||
August 1, 2008, 17:38
|
prism meshing???
|
#1 |
|
Guest
Posts: n/a
|
can anybody tell me, why prism meshing is assigned while making tetra mesh.
thanks for the reply... |
|
|
||
|
August 1, 2008, 19:35
|
Re: prism meshing???
|
#2 |
|
Guest
Posts: n/a
|
u do prism mesh when you want this type of mesh! you use this prism mesh for de boundary layer.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Getting prism to inflate into mixed tet-hex meshes | Joe | CFX | 16 | October 10, 2011 08:06 |
| [ICEM] No quads after prism meshing | saisanthoshm88 | ANSYS Meshing & Geometry | 2 | February 6, 2011 06:28 |
| [ICEM] Prism meshing | itsayapan | ANSYS Meshing & Geometry | 2 | May 28, 2010 05:52 |
| Prism meshing in ICEM 11.0.1 | carno | FLUENT | 0 | April 1, 2008 08:24 |
| Icemcfd: Preventing prism inflation collisions? | Joe | CFX | 1 | July 31, 2007 10:13 |
Linear Mode
