Icem "imprint face" command

July 24, 2008, 13:49

Hi, i want to know if there is a command like "imprint faces" from ansys workbench on icem. I generated a mesh and exported to CFX but my Inlet doest appear. My inlet is a part of the wall

icem -> http://img146.imageshack.us/my.php?image=inletfo1.jpg

cfx pre -> http://img504.imageshack.us/my.php?image=inlet2dm1.jpg

as you can see, the inlet doesnt appear, just saida (outlet) simetria (simmetry) piso (heated floor) and paredes (adiabatic wall)

thank you in advance

July 24, 2008, 16:28

I figured out my problem. I was using 3 blocks, now im using 4 block (the new one in on the inlet).

Problem solved

July 24, 2008, 13:49	Icem "imprint face" command	#1
Lindner Guest Posts: n/a	Hi, i want to know if there is a command like "imprint faces" from ansys workbench on icem. I generated a mesh and exported to CFX but my Inlet doest appear. My inlet is a part of the wall icem -> http://img146.imageshack.us/my.php?image=inletfo1.jpg cfx pre -> http://img504.imageshack.us/my.php?image=inlet2dm1.jpg as you can see, the inlet doesnt appear, just saida (outlet) simetria (simmetry) piso (heated floor) and paredes (adiabatic wall) thank you in advance

July 24, 2008, 16:28	Re: Icem "imprint face" command	#2
Lindner Guest Posts: n/a	I figured out my problem. I was using 3 blocks, now im using 4 block (the new one in on the inlet). Problem solved

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
area does not match neighbour by ... % -- possible face ordering problem	St.Pacholak	OpenFOAM	11	September 4, 2024 05:28
how to set periodic boundary conditions	Ganesh	FLUENT	15	November 18, 2020 07:09
[Gmsh] Import problem	ARC	OpenFOAM Meshing & Mesh Conversion	0	February 27, 2010 11:56
OpenFOAM15 installables are incomplete problem with paraFoam	tryingof	OpenFOAM Bugs	17	December 7, 2008 05:41
WARNING: non-positive face area exist.	Alan	Main CFD Forum	4	August 17, 2006 08:33