 |
 |
 |
|
|
|
[Sponsors] | ||||
July 21, 2008, 09:40
|
Global Initialisation
|
#1 |
|
Guest
Posts: n/a
|
Dear All,
I am new in CFX. I want to know what is the impact of Global Initalisation parameters on the overall result? Presently I am doing steady state CFD. Is it necessary to give Global Initialisation ? In which kind of CFD analysis Global Initalisation is necessary? What is the fundamental behind Global Initalisation? Hope to see Positive reply ASAP. Best Regards, Chirag Shah |
|
|
||
|
July 21, 2008, 09:54
|
Re: Global Initialisation
|
#2 |
|
Guest
Posts: n/a
|
I think it will help to converge faster if you have a good guess for the initialisation in steady state simulation. But it is necessary to have a reasonalbe initialization for unsteady simulation.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to write k and epsilon before the abnormal end | xiuying | OpenFOAM Running, Solving & CFD | 8 | August 27, 2013 16:33 |
| Upgraded from Karmic Koala 9.10 to Lucid Lynx10.04.3 | bookie56 | OpenFOAM Installation | 8 | August 13, 2011 05:03 |
| Convergence moving mesh | lr103476 | OpenFOAM Running, Solving & CFD | 30 | November 19, 2007 15:09 |
| IcoFoam parallel woes | msrinath80 | OpenFOAM Running, Solving & CFD | 9 | July 22, 2007 03:58 |
| Could anybody help me see this error and give help | liugx212 | OpenFOAM Running, Solving & CFD | 3 | January 4, 2006 19:07 |
Linear Mode
