|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
Hi Glenn,
I am simulating a case of pool fire. When i am putting real mass flow in than the flame seems to be unrealistic and the flame is running away from its source though it works prettily when a mass flow is reduced by 100 times than i get a good shape of flame. I am not able to understand why did it happen? Should i go for a profile shape at inlet or some other idea would be a great help. Thanks in advance! Regards Manu |
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
Hi,
We will need a lot more detail about what you are modelling before we can help. Glenn Horrocks |
|
![]() |
![]() |
![]() |
#3 |
Guest
Posts: n/a
|
Hi Glenn, The inlet mass flow i am prescribing is the measured burning rate of my fuel. Now i have opening everywhere except bottom wall where the pan is kept and pan wall which are no slip adiabatic walls. Now i am using k- epsilon turbulence model, eddy dissipation (single step chemistry) combustion model, discrete radiation transfer and Magnussen soot models. Now the problem is when i start my simulation (lets say steady state and without soot model) with real mass flow, i get a flame far away from inlet ( like a diffuser ). When i reduce this inlet mass flow by 100 times i get a good conical shape flame ( thats what i can expect from single step chemistry). What should i understand from this? Is this real mass flow is numerically unphysical? Please help me if you can.
Regards Manu |
|
![]() |
![]() |
![]() |
#4 |
Guest
Posts: n/a
|
Hi,
Sounds like you need more detailed assistance than is possible on the forum. I would contact your CFX support representative. Glenn Horrocks |
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Mass flow inlet and pressure outlet issue | nikhil | FLUENT | 5 | December 11, 2013 13:30 |
Combination of mass flow inlet and pressure inlet boundaries | MrStuebb | Main CFD Forum | 0 | January 6, 2011 10:59 |
velocity calculations in mass flow inlet boundary condition | montazer1012 | FLUENT | 1 | October 18, 2010 04:11 |
Mass Flow Inlet with Velocity specification | bernarde | STAR-CCM+ | 1 | December 4, 2009 00:13 |
Mass Flow Inlet | Pravir Kumar Rai | FLUENT | 0 | February 17, 2003 20:23 |