|
[Sponsors] |
July 3, 2008, 06:33 |
valve simulation in ansys cfx
|
#1 |
Guest
Posts: n/a
|
I'm a studente, I'm trying to simulate an engine's valve but I'have got some problems during simulations: I can't complitley separate the 2 fluid part for skewness error when the two surface are really close. I hope in your suggestions.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Compressible Flow in Ansys CFX | bcheruk | CFX | 15 | July 6, 2017 07:30 |
simulation of a radial hydrodynamic bearing in ANSYS CFX | Jalen | ANSYS | 1 | October 4, 2013 11:40 |
Problems on H2/air CFX simulation | xulixian | OpenFOAM Running, Solving & CFD | 2 | April 14, 2009 16:00 |
2D Simulation ANSYS CFX | antonello | CFX | 2 | December 20, 2007 04:12 |
Exporting results from CFX to ANSYS ?? | sohail ahmed | CFX | 1 | December 20, 2007 02:10 |