extrude 2D mesh

June 8, 2008, 06:34

Hi everybody,

I would like to know if it is possible to make at once in 2D extrude mesh in cfx for 3 or more parts.In Advancing front and inflation 3D i can make more periodicity pairs, but when i swith the option to extrude 2D mesh, only one extrude pair is valid.Can you give me some usefull information please?

Thanks.

June 8, 2008, 22:41

Hi Stefan,

You can pick more than one surface for each side. Try including on face from all three parts in each side of your periodic pair.

Alternatively, you can use the sweep method, instead of the CFX-Mesh method, or you can assign a separate CFX-Mesh method to each part.

-CycLone

June 8, 2008, 06:34	extrude 2D mesh	#1
stefan Guest Posts: n/a	Hi everybody, I would like to know if it is possible to make at once in 2D extrude mesh in cfx for 3 or more parts.In Advancing front and inflation 3D i can make more periodicity pairs, but when i swith the option to extrude 2D mesh, only one extrude pair is valid.Can you give me some usefull information please? Thanks.

June 8, 2008, 22:41	Re: extrude 2D mesh	#2
CycLone Guest Posts: n/a	Hi Stefan, You can pick more than one surface for each side. Try including on face from all three parts in each side of your periodic pair. Alternatively, you can use the sweep method, instead of the CFX-Mesh method, or you can assign a separate CFX-Mesh method to each part. -CycLone

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] Number of cells in mesh don't match with size of cellLevel	colinB	OpenFOAM Meshing & Mesh Conversion	14	December 12, 2018 09:07
[ICEM] Hexa mesh, curve mesh setup, bunching law	Anorky	ANSYS Meshing & Geometry	4	November 12, 2014 01:27
[ICEM] Generating Mesh for STL Car in Windtunnel Simulation	tommymoose	ANSYS Meshing & Geometry	48	April 15, 2013 05:24
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere!	sc298	OpenFOAM Meshing & Mesh Conversion	2	March 27, 2011 22:11
ICEM extrude mesh by rotation	derkaiser	ANSYS	0	December 21, 2009 06:01