 |
 |
 |
|
|
|
[Sponsors] | ||||
November 6, 2024, 20:31
|
Erosion Analysis in Centrifugal Compressor
|
#1 |
|
New Member
Wajahat Hussain
Join Date: Oct 2024
Location: Beijing China
Posts: 2
Rep Power: 0  |
Hi everyone!
I am doing an erosion analysis on the blades of the centrifugal compressor. I am trying to predict the erosion map but facing an issue. During the sand particles injection, the Leading edge of the blade is the most affected area but in my case, it shows the trailing edge as the most affected one. Can anyone tell me please why is it happening? I am using ANSYS CFX for my simulations. |
|
|
|
|
|
November 8, 2024, 03:51
|
|
#2 |
|
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,871
Rep Power: 144 |
It is happening because you have not set up the simulation correctly.
What have you got wrong on the setup? Well, that is the tricky bit. This FAQ may help: https://www.cfd-online.com/Wiki/Ansy..._inaccurate.3F
__________________
Note: I do not answer CFD questions by PM. CFD questions should be posted on the forum. |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Transient Analysis Of axial compressor | rohit_turbo | CFX | 4 | May 20, 2016 03:39 |
| Possible to simulate a working Centrifugal Compressor for jet engine on OpenFOAM? | fazlur | OpenFOAM | 1 | August 21, 2013 05:30 |
| Centrifugal compressor mass flow error | Attesz | CFX | 18 | May 27, 2012 11:17 |
| [ICEM] Meshing a centrifugal compressor impeller | Mitpostdoc | ANSYS Meshing & Geometry | 8 | February 25, 2011 11:51 |
| The Onset of Surge in a centrifugal compressor | Suzzn | CFX | 4 | December 19, 2009 09:49 |
Linear Mode
