 |
 |
 |
|
|
|
[Sponsors] | ||||
May 14, 2008, 14:42
|
ran out of temporary space
|
#1 |
|
Guest
Posts: n/a
|
Have u seen this error massage?
ERROR #001100279 has occurred in subroutine ErrAction. | | Message: | | SYMASS_ZIFCS_EL : The solver ran out of temporary space while bui- | | lding a linked list for a domain interface. Try setting the expe- | | rt parameter "topology estimate factor zif" to a value greater th- | | an 1.0. Values higher than 1.2 should not be necessary. I have set the expert parameter to 1.2 but I still recieve the same error. I was able to run a file larger than this ERROR #001100279 has occurred in subroutine ErrAction. |
|
|
||
|
May 27, 2011, 10:09
|
|
#2 |
|
Member
Join Date: Jan 2011
Posts: 37
Rep Power: 15  |
yes i have see nti now when i tried to transfer mesh from icem to cfx and tried to run it
 .Did u get the solution bychance
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| RAM and Swap Space and HD space | Anindya | Siemens | 2 | May 25, 2016 22:40 |
| Connect two pipes with different space stap | CFDDmitry | Main CFD Forum | 0 | May 19, 2011 08:24 |
| Error Message - No Space | recon9 | CFX | 3 | January 29, 2011 14:41 |
| How to model the NR eqns in a domain with empty space | Vasilis | Main CFD Forum | 1 | April 14, 2009 05:35 |
| Fatal error error writing to tmp No space left on device | maka | OpenFOAM Installation | 2 | April 3, 2006 09:48 |
Linear Mode
