 |
 |
 |
|
|
|
[Sponsors] | ||||
March 13, 2008, 11:16
|
About Multiblock setup
|
#1 |
|
Guest
Posts: n/a
|
I want to compute a foil in water tunnel. I want to make a C-grid of it. So I devide two block of it: one is front area and the other is rear area. However, I can't keep the grids continual between these two block though the boundary. Although I chose the same ratio and spacing.
Maybe anybody has better method to build a C-grid? How can I do with it ? Thanks in advance! |
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Hexa mesh, curve mesh setup, bunching law | Anorky | ANSYS Meshing & Geometry | 4 | November 12, 2014 01:27 |
| Setup Cell Error in Fluent on Workbench | tolu | FLUENT | 1 | September 12, 2013 14:28 |
| How I can setup Fluent for a Define_Profile on FZ? | Nuno | FLUENT | 5 | February 23, 2012 04:39 |
| 2D setup and 2D profile data file in CFX10 | Se-Hee | CFX | 3 | October 30, 2006 10:49 |
| setup vof test problem | Fang Jin | FLUENT | 1 | June 14, 2005 09:27 |
Linear Mode
