cannot run solver if body spacing less than 1

February 28, 2008, 05:06

Hi all,

I created one micro channel and try to simulate fluid flow inside the channel. For default body spacing 1 inside cfx-mesh, i don't have any problem running cfx-solver..but when come to 0.5 body spacing...the solver end up with licensing error.

any one here know what is the problem?

February 28, 2008, 17:41

Hi,

You might have a license which limits the solver to small simulations. I think some academic teaching licenses have this restriction on them.

Glenn

February 28, 2008, 05:06	cannot run solver if body spacing less than 1	#1
wan Guest Posts: n/a	Hi all, I created one micro channel and try to simulate fluid flow inside the channel. For default body spacing 1 inside cfx-mesh, i don't have any problem running cfx-solver..but when come to 0.5 body spacing...the solver end up with licensing error. any one here know what is the problem?

February 28, 2008, 17:41	Re: cannot run solver if body spacing less than 1	#2
Glenn Horrocks Guest Posts: n/a	Hi, You might have a license which limits the solver to small simulations. I think some academic teaching licenses have this restriction on them. Glenn

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
ANSYS Workbench on "Uncertified" Linux Distros	hsr	CFX	289	April 20, 2023 10:23
How to run a solver on a machine without installation of OpenFOAM	waynezw0618	OpenFOAM Running, Solving & CFD	4	June 24, 2017 13:07
Working directory via command line	Luiz	CFX	4	March 6, 2011 21:02
Error during the solver run	Roland R	CFX	2	August 31, 2010 03:16
ATTENTION! Reliability problems in CFX 5.7	Joseph	CFX	14	April 20, 2010 16:45