 |
 |
 |
|
|
|
[Sponsors] | ||||
February 7, 2008, 13:11
|
Setting Roughness on a Solid-Fluid Interface
|
#1 |
|
Guest
Posts: n/a
|
In a CHT simulation, is it possible to set roughness on the solid side of interface? If the answer is yes, how ? Thak You.
|
|
|
||
|
February 7, 2008, 14:41
|
Re: Setting Roughness on a Solid-Fluid Interface
|
#2 |
|
Guest
Posts: n/a
|
Dear JensonButton,
The roughness is set on the fluid side of the interface.. The solid side is within the solid and the roughness has no meaning then. It is just interpretation on what a side means, Hope it helps, Opaque. |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Radiation at interface between fluid and porous domain | Hitch8 | CFX | 19 | April 20, 2015 07:24 |
| Re-meshing a deformable solid body in a fluid | brashear | CFX | 6 | December 12, 2011 12:13 |
| solid to fluid heattransfer with chtMultiRegionFoam | nakor | OpenFOAM | 11 | March 21, 2011 09:28 |
| solidWallHeatFluxTemperature at the solid solid interface in chtMultiRegionSimpleFoam | maddalena | OpenFOAM Running, Solving & CFD | 43 | January 11, 2011 03:39 |
| Cells with t below lower limit | Purushothama | Siemens | 2 | May 31, 2010 22:58 |
Linear Mode
