Hello there.

How can I tell the solver to interpolate the data from initial file into my def, using command line?

Thanks

You can see the solver commands by running >cfx5solve -help
To specify an initial values file (myRun_001.res), add a -ini flag:
>cfx5solve myNewRun.def -ini myRun_001.resIn this case it will use the mesh and results from myRun_001.res and physics CCL from myNewRun.def. This essentially amounts to a change of physics for myRun_001.res as opposed to starting myNewRun.def.
To interpolate the results onto myNewRun.def, add the -inter-iv flag:
>cfx5solve myNewRun.def -ini myRun_001.res -interp-ivIn this case only the solution is interpolated and the mesh in myNewRun.def is kept. All counters reset to zero.

-CycLone

woow when would i learn all this. What do you do CycLone. How many Phds do you have in CFD?

I listen and ask a lot of questions ...and I don't have a PhD.