Sliding Mesh

fardin.sh · July 9, 2023, 16:35

Hello everybody, I have two domains as shown in pic. The Square one is constant domain (not moving) but the inner square is rorating and there should be a connection between these two domains.

Link

Can any body help me out?

ghorrocks · July 9, 2023, 19:45

There is no image on your post. See this FAQ on how to post images: https://www.cfd-online.com/Wiki/Ansy...n_the_forum.3F

But I think I know the answer to your question anyway. To connect two mesh regions which slide (translate) relative to each other you should use a GGI, set to transient rotor stator. That will resolve the interface correctly from fully shut, partial open to fully open.

fardin.sh · July 10, 2023, 13:48

Quote:

Originally Posted by ghorrocks

There is no image on your post. See this FAQ on how to post images: https://www.cfd-online.com/Wiki/Ansy...n_the_forum.3F

But I think I know the answer to your question anyway. To connect two mesh regions which slide (translate) relative to each other you should use a GGI, set to transient rotor stator. That will resolve the interface correctly from fully shut, partial open to fully open.

------------------

Fixed. Please look again.

ghorrocks · July 10, 2023, 20:28

Does the inner block do a circular motion, keeping its outer edge as an interface to the outer block?

If so then this is easily done using a rotating frame of reference for the inner block, and joined to the outer block with a GGI set to transient rotor-stator.

The CFX tutorials on turbomachinery will show you how to set these simulations up.

July 9, 2023, 19:45		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,870 Rep Power: 144	There is no image on your post. See this FAQ on how to post images: https://www.cfd-online.com/Wiki/Ansy...n_the_forum.3F But I think I know the answer to your question anyway. To connect two mesh regions which slide (translate) relative to each other you should use a GGI, set to transient rotor stator. That will resolve the interface correctly from fully shut, partial open to fully open. __________________ Note: I do not answer CFD questions by PM. CFD questions should be posted on the forum.

July 10, 2023, 20:28		#4
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,870 Rep Power: 144	Does the inner block do a circular motion, keeping its outer edge as an interface to the outer block? If so then this is easily done using a rotating frame of reference for the inner block, and joined to the outer block with a GGI set to transient rotor-stator. The CFX tutorials on turbomachinery will show you how to set these simulations up. __________________ Note: I do not answer CFD questions by PM. CFD questions should be posted on the forum.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
3D CFD Sliding Mesh Problem, nodes on the interface side not moving.	vaibhavvsr	FLUENT	0	March 1, 2023 07:48
Getting divergence in dynamic mesh but not sliding mesh	niamhiefitz	FLUENT	0	April 20, 2021 07:08
Dynamic Mesh and Sliding Mesh Simultaneously	reynold92	FLUENT	2	May 9, 2015 16:26
Moving mesh	Niklas Wikstrom (Wikstrom)	OpenFOAM Running, Solving & CFD	122	June 15, 2014 07:20
3D Hybrid Mesh Errors	DarrenC	ANSYS Meshing & Geometry	11	August 5, 2013 07:42