 |
 |
 |
|
|
|
[Sponsors] | ||||
How to input a comma in CFX-Pre/Transfor Mesh/From |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 2, 2007, 05:35
|
How to input a comma in CFX-Pre/Transfor Mesh/From
|
#1 |
|
Guest
Posts: n/a
|
Hi, everyone, I am an new learner on CFX. Recently, when I learnt CFX according to Tutorial 10:Flow in a catalytic Converter, I have to input the following setting, but I can't input the comma like below, and the dialog box can't be dragged horizontally. "Apply Rotation > From 0, 0, 0.16
Apply Rotation > To 0, 1, 0.16" Could anyone help me? Thanks a lot. Susan |
|
|
||
|
November 2, 2007, 08:47
|
Re: How to input a comma in CFX-Pre/Transfor Mesh/
|
#2 |
|
Guest
Posts: n/a
|
Now, I found it. It is the chocked problem of the computer.
|
|
|
|
||
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ATTENTION! Reliability problems in CFX 5.7 | Joseph | CFX | 14 | April 20, 2010 16:45 |
| Electronics Enclosure Analysis with CFX | Simulation Engineer | CFX | 1 | April 22, 2009 12:08 |
| CFX 10's solutions differ from CFX 5.7's | Atit Koonsrisuk | CFX | 4 | July 26, 2006 12:59 |
| subroutine FORTRAN // CFX in Spain | spain | CFX | 0 | May 23, 2006 07:12 |
| FSI using CFX and ANSYS | Bi Chang | CFX | 2 | May 10, 2005 05:47 |
Linear Mode
