 |
 |
 |
|
|
|
[Sponsors] | ||||
October 22, 2007, 14:07
|
transient results
|
#1 |
|
Guest
Posts: n/a
|
Hello,
When calculating transient averages (using the transient statistics feature/arithmetic average). Can you just use the first say 20 seconds to calculate an average of a variable, even though the whole run is 40 seconds. Where do you specify this? In general, can you tell CFX-post only to consider certain timesteps for all calculations? Thanks in advance, N.R. |
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Time averaging results from a transient run | Flow Squad | CFX | 4 | October 24, 2011 10:11 |
| transient simulation of a rotating rectangle | icesniffer | CFX | 1 | August 8, 2009 08:25 |
| Combining Transient results after a backup | Dre | CFX | 9 | February 18, 2008 09:43 |
| intermediate results during a transient run | Michael Skoblin | CFX | 1 | September 25, 2006 15:00 |
| Minimal transient result lokks like full in Post | Korsh Mik | CFX | 14 | July 19, 2005 03:45 |
Linear Mode
