CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > ANSYS > CFX

HELP ICEM beginner degenerate edge

Register Blogs Community New Posts Updated Threads Search

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   October 17, 2007, 13:41
Default HELP ICEM beginner degenerate edge
  #1
guest7777
Guest
 
Posts: n/a
hello,

1) i am going through tuorial of 2D-car and the message 'degenerate edge found' comes up. I have not found anything about this concept in the Help.

2) ICEM crashed in an earlier project when i are created a PRE-MESH and on running again does not find 'surface model' although the mesh should be 2D... I have not created any surfaces and am forced to save the files *.tin and *.blk before it crashes again

Could you please help?
  Reply With Quote

Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
how to set periodic boundary conditions Ganesh FLUENT 15 November 18, 2020 07:09
[ICEM] Complete beginner with ICEM dfitz1000 ANSYS Meshing & Geometry 6 January 17, 2011 17:22
Actuator disk model audrich FLUENT 0 September 21, 2009 08:06
Where's the singularity/mesh flaw? audrich FLUENT 3 August 4, 2009 02:07
fluent add additional zones for the mesh file SSL FLUENT 2 January 26, 2008 12:55


All times are GMT -4. The time now is 09:38.