|
[Sponsors] |
October 15, 2007, 07:20 |
BEGINNER ICEM edges of splitted blocks
|
#1 |
Guest
Posts: n/a
|
Hello, the basic geometry is based on a tutorial and have following issue: 1)split a blocks through edges (big and small), 2)smaller block is associated with geometry_b 3)the bigger block is distorded through edge association of smaller block could you please explain what i should do in order that the blocks are splitted and then become independent of each other? thank you
|
|
October 15, 2007, 08:31 |
Re: BEGINNER ICEM edges of splitted blocks
|
#2 |
Guest
Posts: n/a
|
Which tutorial? Which step is going wrong?
To have two independent blocks.. 1) Create two blocks separately OR 2) Split one block in to three & delete intermediate one 'permanently' By the way, this way you will loose mesh continuity between two blocks. So, check whether you really need it. Best luck, Chirag |
|
October 15, 2007, 12:30 |
Re: BEGINNER ICEM edges of splitted blocks
|
#3 |
Guest
Posts: n/a
|
tutorial 2d-car: i have added a z-dim. to it and initially a 3-d bounding block which i split around car. what happens to the edges of say bigger and smaller block which is splitted? thank you
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Aligned edges in ICEM | RichardG | ANSYS Meshing & Geometry | 28 | March 14, 2017 12:40 |
dsmcInitialise - dsmcFoam | archymedes | OpenFOAM Pre-Processing | 94 | July 15, 2016 17:14 |
[ICEM] Deleting VORFN blocks in ICEM CFD | Sai Swaroop | ANSYS Meshing & Geometry | 5 | October 18, 2011 11:26 |
Merging the blocks in ICEM | saisanthoshm88 | ANSYS Meshing & Geometry | 1 | December 27, 2010 11:14 |
Icem CFD 10: Align vertices of splitted edges | Michele | CFX | 2 | March 11, 2006 11:07 |