 |
 |
 |
|
|
|
[Sponsors] | ||||
August 13, 2007, 21:06
|
Ansys Workbench to ICEM
|
#1 |
|
Guest
Posts: n/a
|
Hello all,
I am pretty new in using ICEM-CFD. I want to know whether ICEM-CFD can read a geometry modelled in ANSYS Workbench. What has to be done to accomplish this? |
|
|
||
|
August 14, 2007, 01:45
|
Re: Ansys Workbench to ICEM
|
#2 |
|
Guest
Posts: n/a
|
Hello Mr Srivatsan,
Yes, the DM file can be read directly in ICEM inside the Workbench. Once the model is done and 'generated' go to the 'Project' tab and then choose 'Proceed to Advanced Meshing'. It opens ICEM CFD inside the Workbench itself with the current geometry in DM. Hope this helps you. Regards Anantha |
|
|
|
||
|
August 14, 2007, 10:48
|
Re: Ansys Workbench to ICEM
|
#3 |
|
Guest
Posts: n/a
|
You can also use File>Import Geometry>Workbench Readers within ICEM CFD to load your DM model.
-CycLone |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ANSYS Workbench on "Uncertified" Linux Distros | hsr | CFX | 289 | April 20, 2023 10:23 |
| PEM Fuel cell module meshes. ICEM vs workbench | aarvay | FLUENT | 24 | March 2, 2020 07:50 |
| [ICEM] what does the different ANSYS ICEM and ANSYS Workbench? | agungwp | ANSYS Meshing & Geometry | 8 | April 12, 2016 05:51 |
| Can't import geometry file from Icem CFD to Ansys Workbench | Julien87 | ANSYS Meshing & Geometry | 1 | July 19, 2011 17:50 |
| How to integrate ICEM CFD with Ansys Workbench ? | radompon | CFX | 9 | July 1, 2009 17:12 |
Linear Mode
