How to create square surface mesh and volume(ICEM)

July 11, 2007, 01:55

How to create square/rectangular surface and volume meshing with ICEM 10 or CFX meshing 10. I can do it for surface but for volume meshing I can not do it.

Please reply me, thx so much

July 11, 2007, 05:53

try using block mesh

July 11, 2007, 11:06

You cannot do that in CFX-Meshm. You can do it in ICEM 10 if you have a Hex-license. If you use ICEM 10, then install the patch, ending up with version 10.0.1. Much better than 10.0.

Gert-Jan

www.bunova.nl

July 16, 2007, 04:38

Thank you for all of your suggests. I will do that and if I have any problem I will aks you again.

July 11, 2007, 01:55	How to create square surface mesh and volume(ICEM)	#1
Areriko Guest Posts: n/a	How to create square/rectangular surface and volume meshing with ICEM 10 or CFX meshing 10. I can do it for surface but for volume meshing I can not do it. Please reply me, thx so much

July 11, 2007, 05:53	Re: How to create square surface mesh and volume(I	#2
unknown Guest Posts: n/a	try using block mesh

July 11, 2007, 11:06	Re: How to create square surface mesh and volume(I	#3
Gert-Jan Guest Posts: n/a	You cannot do that in CFX-Meshm. You can do it in ICEM 10 if you have a Hex-license. If you use ICEM 10, then install the patch, ending up with version 10.0.1. Much better than 10.0. Gert-Jan www.bunova.nl

July 16, 2007, 04:38	Re: How to create square surface mesh and volume(I	#4
areriko Guest Posts: n/a	Thank you for all of your suggests. I will do that and if I have any problem I will aks you again.