 |
 |
 |
|
|
|
[Sponsors] | ||||
June 25, 2007, 04:17
|
Negative static pressure
|
#1 |
|
Guest
Posts: n/a
|
Hi everyone!
I'm simulating a compressible multiphase model using redlich kwong equation of state.My inlet conditions were velocities,reference pressure is 1atm, outlet average static pressure is zero. The results show negative pressure almost in all regions which is a problem for compressible flow according to Cfx help. But when I check the distribution of velocities, even the profile of pressure graph and pressure recovery, the results agree well with experiment. Do you have any suggestion on how to correct the results for static pressure? (e.g. initial conditions, solver control..) Thanks a lot guys! Ariel |
|
|
||
|
June 25, 2007, 18:54
|
Re: Negative static pressure
|
#2 |
|
Guest
Posts: n/a
|
A negative pressure means negative with respect to the reference pressure. I think you should look to abolute pressure which is ref.Pressure+Pressure.
Gert-Jan |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pressure averaging at the outlets. | KM | CFX | 6 | April 1, 2021 07:28 |
| negative static pressure !!!! | Barbara | FLUENT | 15 | April 7, 2018 15:30 |
| channelFoam for a 3D pipe | AlmostSurelyRob | OpenFOAM | 3 | June 24, 2011 14:06 |
| Average static pressure BCs and aircore in cyclone | KM | CFX | 2 | December 17, 2007 21:50 |
| Hydrostatic pressure in 2-phase flow modeling (long) | DS & HB | Main CFD Forum | 0 | January 8, 2000 16:00 |
Linear Mode
