ICEM Extrude faces - Edge params. -- CFD Online Discussion Forums

June 19, 2007, 13:08	ICEM Extrude faces - Edge params.	#1
Santiago Orrego. Guest Posts: n/a	Hello. Im meshing a spiral duct. The duct is composed by 13 sections of different sizes, going from a big section to a small section. Im meshing the duct by creating the blocks of 1 section (the big one), and then extruding the faces and doing the correct association for each section. The problem is that when I extrude the smallest section, each edge conserve the params of each section. I mean, the params of the edge (any edge) in the big section, conserve the same params in the small section (the same edge of the big section). Does any body knows how to unlink that association? I tried setting the params without putting the option COPY SAME TO PARALLEL, but doesnt work. Thanks Santiago.

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to set periodic boundary conditions	Ganesh	FLUENT	15	November 18, 2020 07:09
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere!	sc298	OpenFOAM Meshing & Mesh Conversion	2	March 27, 2011 22:11
[Gmsh] Cannot get the right mesh from gmsh	JinBiao	OpenFOAM Meshing & Mesh Conversion	2	August 31, 2010 05:51
[snappyHexMesh] external flow with snappyHexMesh	chelvistero	OpenFOAM Meshing & Mesh Conversion	11	January 15, 2010 20:43
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 12:55

All times are GMT -4. The time now is 14:19.