|
[Sponsors] |
May 17, 2007, 13:11 |
Spline through multiple keypoints
|
#1 |
Guest
Posts: n/a
|
Hello I am trying to use Bspline and spline command for generating a spline through airfoil data points from Command line in ANSYS. However, the Bspline and spline commands do not allow more than 6 points at a time. Can someone tell me if different command is used for more than six points (I have well over 25 points). Thanks Liaquat
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 07:09 |
OpenFOAM static build on Cray XT5 | asaijo | OpenFOAM Installation | 9 | April 6, 2011 13:21 |
Multiple domain/Multiple material problems... possible or not? | Amiga500 | OpenFOAM | 1 | April 14, 2010 16:32 |
Spline in DesignModeler? | Edu-R | ANSYS Meshing & Geometry | 1 | April 4, 2010 19:04 |
Multiple reference frames? | Moon | Siemens | 0 | March 4, 2003 07:32 |