|
[Sponsors] |
May 14, 2007, 04:58 |
Newtons method failed(Error)
|
#1 |
Guest
Posts: n/a
|
hey all, after giving all coal boundary condition, i got following error drring solver. Please help me to understand this error.
****** Notice ****** | | Newtons method failed to converge in 100 iterations. This | | occurred while computing the following variable: | | | | Variable Name : Temperature | | Location Name : Domain 1 | | Mesh location : VERTICES | | Mesh entity : | | Last 3 Changes : 3.92441E+05 3.92441E+05 3.92441E+05 | | Tolerance : 1.0000E-02 | | | | The Newton iteration was either slowly converging or has stalled. | | The solver will continue with the variable set as it was on the | | final iteration. If this situation continues you might try | | increasing the number of iterations allowed for Newtons method. | | This can be changed by setting one of the parameters: | | | | Temperature : "Constitutive Relation Iteration Limit" | | Pressure : "Newton Pressure Iteration Limit" | | | | for your mixture using the definition file editor. | Chetan Prashant |
|
May 14, 2007, 07:16 |
Re: Newtons method failed(Error)
|
#2 |
Guest
Posts: n/a
|
Hi Chetan,
it occurs normally when you create a grid in millimeters and forged to scale it to meters in CFX Pre. flga |
|
May 15, 2007, 03:56 |
Re: Newtons method failed(Error)
|
#3 |
Guest
Posts: n/a
|
So what should i do to eliminate this error?
|
|
May 15, 2007, 04:05 |
Re: Newtons method failed(Error)
|
#4 |
Guest
Posts: n/a
|
To scale down your grid in CFX 11 Pre, right click on your grid on the Outline tree, choose "transform mesh". Than set "transformation" to "scale" and write down the coefficient. On CFX 10 I am not sure, but a look into the manual will do the job.
flga |
|
May 17, 2007, 01:58 |
Re: Newtons method failed(Error)
|
#5 |
Guest
Posts: n/a
|
helo flga, thanks for ur reply. but i am still fighting with that problem. so i am giving more description about my problem.
I have introduced plates on wall for taking out heat of furnace with help of imprint commend. Initially I had given less negative flux (45-147W/m2) but it that case temp. Inside furnace is higher and no error. When I am giving higher (45000-147000W/m2)heat negative flux, solver is being stopped with error. (Newtons method failed to converge in 100 iterations) please give me ur suggestion. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Newton's method failed to converge | Mohan | CFX | 7 | September 23, 2020 07:50 |
Newtons method failed to converge in 100 iterations | brajh11 | CFX | 5 | September 3, 2011 07:29 |
Newtons Method failed to converge in 100 iteration | hagupta | CFX | 9 | December 2, 2010 07:41 |
Some discussions about Newton's method | winston | Main CFD Forum | 7 | July 17, 2005 23:05 |
newtons method failed/fatal overflow | ioana | CFX | 0 | March 2, 2005 03:57 |