Hello all,

I have had problems with importing CFX10 data of a transient simulation into CFX11. I have success with steady state simulations.

Below is a list of all the methods I have used with no avail.

Sim. Type TRANSIENT System LINUX

Method CFX10 .def OVERWRITE IN CFX11 Run Mode CFX11 - MPICH DISTRIBUTED PARALLEL/PVM DIST. PARALLEL Result CODE 1ERROR

Method IMPORT CFX10 .def FILE INTO CFX11 SOLVER Run Mode CFX11 - MPICH DISTRIBUTED PARALLEL / PVM DIST. PARALLEL Result CODE 1ERROR

Method IMPORT CFX10 .cfx FILE INTO CFX11 - FAIL TO IMPORT

Method IMPORT CFX10 .gtm FILE INTO CFX11 - CREATE BC IN CFX11 Run Mode CFX11 - MPICH DISTRIBUTED PARALLEL Result CODE 1ERROR

Method IMPORT ICEM MESH INTO CFX11PRE - CREATE BC IN CFX11 Run Mode CFX11 - PVM DIST. PARALLEL Result CODE 1ERROR

Method IMPORT ICEM MESH INTO CFX11PRE - CREATE BC IN CFX11 Run Mode CFX11 - MPICH DIST. PARALLEL Result PIPE 13 ERROR

Method IMPORT ICEM MESH INTO CFX11PRE - CREATE BC IN CFX11 Run Mode CFX11 - PVM DIST. PARALLEL Result CODE 1 ERROR

I thank you kindly for your help.

Regards,

Steve

Does the transient case run in CFX 10 in parallel? When you import the ICEM mesh into CFX 11 Pre, does this run in serial? Is your version of Linux suported?