|
[Sponsors] |
March 22, 2007, 12:55 |
Monitor residuals
|
#1 |
Guest
Posts: n/a
|
I have read in the manual that setting to T the expert parameter "monitor residuals" that is inside I/O control you can later, in the post, see the different residual values. But I don´t have this option, why? what can I do to now where do i have a problem in the solution?
explanation on the manual: monitor residuals When set to T, outputs maximum residuals and locations for each coefficient loop in a steady state simulation or for each timestep in a transient simulation). |
|
March 22, 2007, 14:34 |
Re: Monitor residuals
|
#2 |
Guest
Posts: n/a
|
Look under the expert parameters tab in Pre.
|
|
March 22, 2007, 15:04 |
Re: Monitor residuals
|
#3 |
Guest
Posts: n/a
|
But there isn´t a monitor residuals option. Is the same using "monitor scales" or what should I do? Thanks for answering.
|
|
March 26, 2007, 05:00 |
Re: Monitor residuals
|
#4 |
Guest
Posts: n/a
|
Within Solver, choose Tools / Edit Definition File / Add Expert Parameter Section. Highlight Expert Parameter Section and then Add Parameter and choose from list.
|
|
March 26, 2007, 08:25 |
Re: Monitor residuals
|
#5 |
Guest
Posts: n/a
|
Thanks. Using this parameter is the same as choosing "monitor residuals" on the output control at pre??
|
|
|
|