ICEM - control over the names for vertices...

February 5, 2007, 06:06

Hello,

I have a question regarding ICEM.

Sometimes, when creating some new surfaces (for exemple when using Sweep surface), ICEM creates automatically some new points and curves. It gives some strange names to these points and curves (for exemple CURVES.01e10). Does someone understand how ICEM generates such names and how can we interact on them ?

Best regards,

Hervé

February 5, 2007, 09:57

I doubt the user has any way of controlling the auto-generated names. But users can always change the entity name after the fact.

February 5, 2007, 06:06	ICEM - control over the names for vertices...	#1
HervÃ© Guest Posts: n/a	Hello, I have a question regarding ICEM. Sometimes, when creating some new surfaces (for exemple when using Sweep surface), ICEM creates automatically some new points and curves. It gives some strange names to these points and curves (for exemple CURVES.01e10). Does someone understand how ICEM generates such names and how can we interact on them ? Best regards, Hervé

February 5, 2007, 09:57	Re: ICEM - control over the names for vertices...	#2
myron Guest Posts: n/a	I doubt the user has any way of controlling the auto-generated names. But users can always change the entity name after the fact.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Control of output folder names	Misha	OpenFOAM	3	January 31, 2011 08:53
element size control in ICEM (line & face spacing)	Sam	CFX	0	January 28, 2008 14:28
Design Modeler to ICEM.....	Joe	CFX	0	January 24, 2008 04:39
Local mesh control in ICEM (for hex mesh)	Debabrata Mahapatra	CFX	1	October 17, 2007 11:45
domain names - how to specify in Icem Hexa	Dr. Flow Squad	FLUENT	4	March 15, 2007 07:54