 |
 |
 |
|
|
|
[Sponsors] | ||||
January 16, 2007, 10:10
|
Mismatch node
|
#1 |
|
Guest
Posts: n/a
|
why there always mismatch at periodic node after i generate the surface mesh?why its difficult to generate mesh at small internal angle?
Thank You. |
|
|
||
|
January 16, 2007, 10:12
|
Re: Mismatch node
|
#2 |
|
Guest
Posts: n/a
|
In icem CFD you must specify the surface pairs are periodic to avoid this.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Export node number and coordinates | kezman | CFX | 2 | November 7, 2015 16:45 |
| Accessing node values using a UDF | Nico | FLUENT | 2 | December 20, 2007 03:50 |
| License server not visible from master node | Charles | FLUENT | 0 | October 30, 2007 18:48 |
| how can i list node temperatur by node location | Ali Doustdar | FLUENT | 2 | July 13, 2007 00:48 |
| [Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 05:15 |
Linear Mode
