 |
 |
 |
|
|
|
[Sponsors] | ||||
April 10, 2021, 07:01
|
CFX Convergence Problem-Steady State
|
#1 |
|
New Member
ANGELO
Join Date: Jul 2020
Posts: 12
Rep Power: 6  |
Hi,
I am simulating a cylinder(D=0.2m, L=0.8m) rotating at 34 rad/s immersed in a cylindrical volume of Air(D=1m, L=1m). The cylinder has two plates on both sides to simulate the effect of endplates and the cylinder is only rotating. I have a value of y+ =2.5 and a good quality of mesh=0.7. The problem is that the solution is not converging even if I keep it running for 12 hours, it keeps oscillating arround 1.5*10-4(I am using steady state). The aim of the simulation is to determine the torque on the cylinder wall and then the friction coefficient Cf. Before simulating the cylinder with the endplates the solution converged and everything worked good. Can anyone help me please regarding the convergence problem. Enclosed the geometry image and the residual screenshot. Thanks, Angelo |
|
|
|
|
|
April 10, 2021, 07:59
|
|
#2 |
|
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,872
Rep Power: 144 |
__________________
Note: I do not answer CFD questions by PM. CFD questions should be posted on the forum. |
|
|
|
|
|
 |
| Tags |
| cfx, convergence problems, steady state |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Domain Reference Pressure and mass flow inlet boundary | AdidaKK | CFX | 75 | August 20, 2018 06:37 |
| Convergence in Transient; Divergence in Steady State | artkingjw | FLUENT | 6 | May 24, 2018 03:51 |
| Convergence in steady state simulations vs transient ones | cardioCFD | CFX | 5 | January 21, 2018 11:59 |
| [ICEM] issue occur after extrude 2D airfoil mesh and convergence problem in CFX | shiyun | ANSYS Meshing & Geometry | 4 | May 9, 2012 20:55 |
| Steady State 2 phase problem | fivos | FLUENT | 0 | April 27, 2009 17:34 |
Linear Mode
