hello everybody,

i am modeling liquid solid flows in riser,i want to specify the wall boundary as a partial slip for solid phase and no slip for liquid phase.

is there any way to specify the partial slip bounday condition in CFX 10.0

thanks

bye CFDUSER

Dear CFDUSER,

1 - Go to CFX-Pre, open wall boundary panel

2 - On the boundary details tab, under Wall Influence on the Flow select Fluid Dependent..

3 - On the Fluid Values tab, fill in the Free Slip and No Slip conditions for each fluid under Wall Influence on the Flow

Opaque

Dear opaque

thanks for your comments, i am asking setup of user defined partial slip boundary for solid phase

with regards CFDUSER