|
[Sponsors] |
How do I set Lower temperature boundary limit? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 4, 2006, 03:31 |
How do I set Lower temperature boundary limit?
|
#1 |
Guest
Posts: n/a
|
Hi
I am doing a steady state couple field electro-thermal analysis in ANSYS. I would like to set lower boundary limit for temperature i.e, temperature should not go below certain temperature. It can be free to assume any higher temperature value. Could you please inform me how can I accomplish this? Thanking you, Arefin Anwar Concordia University |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 04:32 |
How to show the transient case? | H.P.LIU | Phoenics | 7 | July 13, 2010 05:31 |
OF 1.6 | Ubuntu 9.10 (64bit) | GLIBCXX_3.4.11 not found | piprus | OpenFOAM Installation | 22 | February 25, 2010 14:43 |
How do I set lower temperature boundary limit? | Arefin Anwar | CFX | 1 | December 4, 2006 10:48 |
Water vapour condensation in CFX-5.7.1 | hdj | CFX | 1 | November 27, 2005 08:15 |