Blocking problem with ICEMCFD

November 29, 2006, 09:16

Hello,

I have a problem with ICEMCFD and blocking. I must mesh a complex geometry, plenum for turbine blade with approximately 100 holes, and after I create a lot of blocks and Ogrid in holes, the software calculates and dont respond eternally to create a new Ogrid block in a hole.

Is there anybody who knows this problem and has a solution ?

Thanks

D. Charbonnier

November 30, 2006, 14:41

Part of the joy of Blocking in ICEM. As the topology gets more and more complex, the response get slower and slower.

November 29, 2006, 09:16	Blocking problem with ICEMCFD	#1
Charbonnier Guest Posts: n/a	Hello, I have a problem with ICEMCFD and blocking. I must mesh a complex geometry, plenum for turbine blade with approximately 100 holes, and after I create a lot of blocks and Ogrid in holes, the software calculates and dont respond eternally to create a new Ogrid block in a hole. Is there anybody who knows this problem and has a solution ? Thanks D. Charbonnier

November 30, 2006, 14:41	Re: Blocking problem with ICEMCFD	#2
myron Guest Posts: n/a	Part of the joy of Blocking in ICEM. As the topology gets more and more complex, the response get slower and slower.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
area does not match neighbour by ... % -- possible face ordering problem	St.Pacholak	OpenFOAM	11	September 4, 2024 05:28
conduction problem	venkataramana	OpenFOAM	3	December 1, 2013 08:30
Problem Importing Geometry ProE to CFX	fatb0y	CFX	3	January 14, 2012 20:42
natural convection problem for a CHT problem	Se-Hee	CFX	2	June 10, 2007 07:29
Adiabatic and Rotating wall (Convection problem)	ParodDav	CFX	5	April 29, 2007 20:13