 |
 |
 |
|
|
|
[Sponsors] | ||||
October 19, 2006, 00:17
|
Condense simulation
|
#1 |
|
Guest
Posts: n/a
|
I am doing a condense simuation using CFX10. It is a simple case that steam inside a pipe is cooled down by outside air.
I have two domains, one for steam and one for air. Can I set different fluids/reference pressure/initial conditions for those two domains? many thanks. |
|
|
||
|
October 23, 2006, 15:46
|
Re: Condense simulation
|
#2 |
|
Guest
Posts: n/a
|
It is possible, but if you set wich domain with only one material your simulation will be single phase flow!
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Why my simulation not agree with the wind tunnel experiment | zhaowei | CFX | 4 | July 11, 2015 04:36 |
| Solar Radiation in OpenFOAM | plainstyle | OpenFOAM Running, Solving & CFD | 15 | July 8, 2014 05:43 |
| Axial fan simulation in UG/NX 7.5 | fan123 | Main CFD Forum | 2 | April 23, 2011 09:22 |
| Simulation of a complex wing in solidworks flow simulation | niels1900 | FloEFD, FloWorks & FloTHERM | 6 | April 20, 2011 11:44 |
| strange simulation error | Ralf Schmidt | FLUENT | 2 | May 4, 2007 14:02 |
Linear Mode
