|
[Sponsors] |
September 29, 2006, 09:49 |
Distributed parallel problem
|
#1 |
Guest
Posts: n/a
|
Hello,
I'm trying to set up a distributed parallel calculation (ANSYS 10, WINNT2000 advanced server). I installed rsh and MPICH for windows according to the manual pg 51 and further. I have a host (#110), 3 slaves (#111, #112 and #113). It's working when I do a calculation on 2 machines (110 and 111). For the other machines I can't get it to work (so the combi 110-112 and 110-113 is not working). Below is the last part of the output of a run when it goes wrong. What can be the problem? Best regards, Maurice Parallel run: Received message from slave ----------------------------------------- Slave partition : 2 Slave routine : ErrAction Master location : RCVBUF,MSGTAG=1052 Message label : 001100279 Message follows below - : +--------------------------------------------------------------------+ | ERROR #001100279 has occurred in subroutine ErrAction. | | Message: | | Stopped in routine RedSht | | | | | | | | | | | +--------------------------------------------------------------------+ |
|
October 2, 2006, 03:47 |
Re: Distributed parallel problem
|
#2 |
Guest
Posts: n/a
|
Ok, I solved it. (Well, CFX Technical support did). On 2 machines I had installed the Service Pack 1, on 2 I did not. It's crucial that the software is identical on all 4 machines. Best regards, Maurice
|
|
October 13, 2006, 10:11 |
Re: Distributed parallel problem
|
#3 |
Guest
Posts: n/a
|
Thank you very much. We really appreciate your suggestion. Regards.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
problem in the CFX12.1 parallel computation | BalanceChen | ANSYS | 2 | July 7, 2011 11:26 |
problem using property udfs in parallel mode | EllenW | FLUENT | 0 | June 23, 2009 18:18 |
parallel UDF problem | kerem | FLUENT | 2 | June 20, 2006 07:56 |
Problem using parallel Fluent | Gustavo | FLUENT | 0 | June 28, 2004 00:12 |
cfx4 parallel sover Problem!! HELP | Richard.A | CFX | 2 | August 3, 2002 04:54 |