|
[Sponsors] |
September 25, 2006, 14:19 |
intermediate results during a transient run
|
#1 |
Guest
Posts: n/a
|
Hello all. I have suddenly run into a problem of saving intermediate data. I set "Selected Variables" and "Time interval" and formed the list of output. But the first attempt to save intermediate data ends with error of insufficient memory (in the MAKDAT subroutine). The solver "advises" me to increase the size of integer memory stack. Question: how do I do that? I failed to find this possibility in the interface. The funny thing is that I used to save intermediate results many times without any problems, but once I faced this trouble. I made a step backward (used the previous simulation file, which was free of this problem), but the trouble persisted. Thanks, Michael
|
|
September 25, 2006, 15:00 |
Re: intermediate results during a transient run
|
#2 |
Guest
Posts: n/a
|
Dear Michael,
The memory settings for the ANSYS CFX solver can modified in the Solver Manager under Define Run/Solver tab. If you cannot find the tab, be certain that the Show Advanced Controls is toggled under Define Run/Run Definition. Also, you can find the command line flags by cfx5solve -help Good luck, Opaque |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to map results from steady state run to tranient case? | phsieh2005 | OpenFOAM Running, Solving & CFD | 2 | November 7, 2010 07:20 |
Error reading transient results | Magnoli | CFX | 3 | March 4, 2010 09:29 |
courant number for cfx transient run | Mike | CFX | 8 | April 7, 2006 00:48 |
Combining transient results | Shazlan | Siemens | 3 | April 13, 2005 06:49 |
transient run and residuals | Mark | Main CFD Forum | 4 | April 21, 2004 11:12 |