|
[Sponsors] |
July 11, 2006, 03:56 |
water injection into air (not spray)
|
#1 |
Guest
Posts: n/a
|
Hi everyone I want to simulate that model described as following: An horizontal injector was set 1.0 meter high above the ground and water injected from this injector and into air in 0.5 m/sec. Could I use CFX-10 to solve this problem? I have try two different settings: 1. free surface model; water and air are both continuous; homogeneous; 2. eulerian model; air is continuous and water is dispersed. But these two parameters also can not be calculated because of fetal error about linear solution. Who can teach me how to set correct domain conditions and boundary conditions?
|
|
July 11, 2006, 06:34 |
Re: water injection into air (not spray)
|
#2 |
Guest
Posts: n/a
|
Read the "Best practices for multiphase flow" in the manual appendix.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 05:21 |
water spray in hot air | krish | FLUENT | 6 | April 3, 2013 08:58 |
water injection into air (spray) | dzinks0 | CFX | 4 | February 16, 2012 17:39 |
air bubble is disappear increasing time using vof | xujjun | CFX | 9 | June 9, 2009 07:59 |
Help!!!problems in air jet into water bath | kim | FLUENT | 4 | June 9, 2003 07:04 |