 |
 |
 |
|
|
|
[Sponsors] | ||||
June 9, 2006, 08:07
|
Temperature outside ranges
|
#1 |
|
Guest
Posts: n/a
|
Hi,
if have a problem with the temperature in my simulation. I simulate a two-phase flow of water and hot gas (water: 323 K and gas 411 K). In the post I can see that there are regions with 0 K and regions up to 1100 K. This can't be possible!!! Any ideas? Thanks |
|
|
||
|
June 9, 2006, 09:08
|
Re: Temperature outside ranges
|
#2 |
|
Guest
Posts: n/a
|
Probably an ill posed problem and/or convergence issues.
Post your command file for inspection ... |
|
|
|
||
|
June 12, 2006, 07:41
|
Re: Temperature outside ranges
|
#3 |
|
Guest
Posts: n/a
|
I think its too long... But I can answer any question about it.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem with zeroGradient wall BC for temperature - Total temperature loss | cboss | OpenFOAM | 12 | October 1, 2018 07:36 |
| Calculation of the Governing Equations | Mihail | CFX | 7 | September 7, 2014 07:27 |
| Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 04:32 |
| High temperature methane+air | Peter | FLUENT | 5 | January 26, 2009 19:04 |
| chemical reaction - decompostition | La S. Hyuck | CFX | 1 | May 23, 2001 01:07 |
Linear Mode
