 |
 |
 |
|
|
|
[Sponsors] | ||||
June 6, 2006, 03:18
|
Help me please. Notice in Pre-solver
|
#1 |
|
Guest
Posts: n/a
|
Dear Friends,
Cfx-solver gave me the following Notice: Wall heat transfer coefficient written to the results file was "wall adjacent temperature" for the bulk temperature. If you want to override the bulk temperature then set the expert parameter "tbulk for heat tran coef = <value>" The fluid in my simulation in compressible air, could you help me to improve the setting in Cfx,Many thanks. Eric |
|
|
||
|
June 6, 2006, 06:34
|
Re: Help me please. Notice in Pre-solver
|
#2 |
|
Guest
Posts: n/a
|
Don't do anything. We all get that message.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Creating New Solver: For particle-laden compressible jets | sankarv | OpenFOAM Running, Solving & CFD | 17 | December 3, 2014 20:41 |
| Quarter Burner mesh with periosic condition | SamCanuck | FLUENT | 2 | August 31, 2011 12:34 |
| notice in CFX solver | sravani | CFX | 3 | September 27, 2007 14:01 |
| Symmetry plane error in solver | Santiago Orrego. | CFX | 6 | January 31, 2007 08:09 |
| Solver Notice in Forced Convection Simulation | Miguel | CFX | 2 | September 21, 2006 16:37 |
Linear Mode
