ERROR #001100279

June 2, 2006, 19:10

hi all, cfx solver have given the following error when running parallel on unix platform after 286 of iteration and i don't know what to do . could anybody explain me how i overcome that error.

regards charles

OUTER LOOP ITERATION = 286 CPU SECONDS = 1.521E+05

Equation Rate | RMS Res | Max Res | Linear Solution |

l U-Mom 0.87 | 5.4E-04 | 9.8E-02 | 7.1E-02 OK|

| V-Mom 0.94 | 5.7E-04 | 1.4E-01 | 2.5E-02 OK|

| W-Mom 0.96 | 2.0E-04 | 2.4E-02 | 2.6E-02 OK|

| P-Mass 2.25 | 2.7E-04 | 2.0E-01 | 12.1 9.1E-02 OK|

| H-Energy 1.01 | 2.9E-04 | 5.4E-02 | 7.2 5.8E-03 OK|

Parallel run: Received message from slave

Slave partition : 4

Slave routine : ErrAction

Master location : RCVBUF,MSGTAG=1032

Message label : 001100279

Message follows below - :

| ERROR #001100279 has occurred in subroutine ErrAction. | Message: | c_fpx_handler: Overflow

June 2, 2006, 19:30

There was an overflow in the solver i.e. solution diverged/crashed. Read the section in the manual entitled "Advice on flow modelling".

June 2, 2006, 19:10	ERROR #001100279	#1
charles Guest Posts: n/a	hi all, cfx solver have given the following error when running parallel on unix platform after 286 of iteration and i don't know what to do . could anybody explain me how i overcome that error. regards charles OUTER LOOP ITERATION = 286 CPU SECONDS = 1.521E+05 Equation Rate \| RMS Res \| Max Res \| Linear Solution \| l U-Mom 0.87 \| 5.4E-04 \| 9.8E-02 \| 7.1E-02 OK\| \| V-Mom 0.94 \| 5.7E-04 \| 1.4E-01 \| 2.5E-02 OK\| \| W-Mom 0.96 \| 2.0E-04 \| 2.4E-02 \| 2.6E-02 OK\| \| P-Mass 2.25 \| 2.7E-04 \| 2.0E-01 \| 12.1 9.1E-02 OK\| \| H-Energy 1.01 \| 2.9E-04 \| 5.4E-02 \| 7.2 5.8E-03 OK\| Parallel run: Received message from slave Slave partition : 4 Slave routine : ErrAction Master location : RCVBUF,MSGTAG=1032 Message label : 001100279 Message follows below - : \| ERROR #001100279 has occurred in subroutine ErrAction. \| Message: \| c_fpx_handler: Overflow

June 2, 2006, 19:30	Re: ERROR #001100279	#2
Joe Guest Posts: n/a	There was an overflow in the solver i.e. solution diverged/crashed. Read the section in the manual entitled "Advice on flow modelling".