 |
 |
 |
|
|
|
[Sponsors] | ||||
November 19, 2019, 02:01
|
Export Conture to Figure
|
#1 |
|
New Member
M S
Join Date: Nov 2019
Posts: 8
Rep Power: 6  |
Dear all,
i have a very long (15m x 0,06 m) block in my thermal simulation. So i cant show the whole conture in some export charts. Is it possible to export the contour values into a chart? In the end i need a figure with x (length) and y(height) and the temperature value as a heatmap. (see attached example) Sorry if this a frequent ask question but i didnt find anything in the forum, maybe i use the wrong keywords. |
|
|
|
|
|
November 19, 2019, 03:25
|
|
#2 |
|
Senior Member
M
Join Date: Dec 2017
Posts: 694
Rep Power: 12 |
You can use the export function of CFD-Post to get your values into a csv file for example. Then you can postprocess the values where you like, Excel, Matlab, ...
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [OpenFOAM.org] Compilation Error with OpenFOAM-5.x using Intel Compilers | aow | OpenFOAM Installation | 4 | April 25, 2019 16:17 |
| Cfd-post - how to export figures automatically? | antonio_dcp | CFX | 1 | October 26, 2017 18:10 |
| A CFX-POST error (ver 14.5.7) | wangyflp88 | CFX | 2 | July 22, 2017 00:17 |
| Abt: Schlieren figure in Tecplot using data | jinwon park | Tecplot | 2 | December 27, 2007 06:48 |
| Latex questiuon (figure) | John Dongarra | Main CFD Forum | 5 | August 22, 2007 10:06 |
Linear Mode
