 |
 |
 |
|
|
|
[Sponsors] | ||||
CFX:getting mass flow rate across a cross section |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 14, 2006, 09:44
|
CFX:getting mass flow rate across a cross section
|
#1 |
|
Guest
Posts: n/a
|
Hi friends, I am doing 3D analysis on a varying area duct. Please can you tell me how to get the mass flow rate across any cross section.
Thanking you, |
|
|
||
|
February 14, 2006, 13:07
|
Re: CFX:getting mass flow rate across a cross sect
|
#2 |
|
Guest
Posts: n/a
|
create plane at the required location in CFX Post. You can use function calculator to calculate mass flow rates across the planes.
|
|
|
|
||
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Particle Injection Mass Flow Rate and Position | leonozx | FLUENT | 3 | March 9, 2018 10:58 |
| Mass flow rate at the outlet | tejasvikrishna | FLUENT | 2 | May 25, 2013 03:42 |
| Mass Flow Rate is not converging | destgir448 | CFX | 5 | December 11, 2010 06:55 |
| 2D axisymmetric mass flow rate for the plain orifice atomizer | jwillie2000 | FLUENT | 2 | September 17, 2010 06:43 |
| Mass Flow Rate Calculation | Paul | FLUENT | 9 | March 23, 2002 09:37 |
Linear Mode
