 |
 |
 |
|
|
|
[Sponsors] | ||||
February 2, 2006, 09:57
|
how to avoid zero volume elements
|
#1 |
|
Guest
Posts: n/a
|
i made a 2d axisymmtery model by rotating it by 1 degree,
and meshed it, but it was showing negative elements, how can i remove it. |
|
|
||
|
February 2, 2006, 20:10
|
Re: how to avoid zero volume elements
|
#2 |
|
Guest
Posts: n/a
|
sameer,
what meshing program are you using? I find ICEM quite good for mesh quality manipulation. |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 07:09 |
| On the damBreak4phaseFine cases | paean | OpenFOAM Running, Solving & CFD | 0 | November 14, 2008 22:14 |
| fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 12:55 |
| [blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 15:00 |
| CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 13, 2001 00:19 |
Linear Mode
