Length Constraint in CFX -- CFD Online Discussion Forums

December 20, 2005, 14:16	Length Constraint in CFX	#1
K B Mishra Guest Posts: n/a	Hi all i m trying to simulate 1000 mm length and 10mm dia pipe in CFX.Somehow solver stops before reaching the no of iterations and seems the mesh transformation is not exactly recognized by CFX.However the full mesh is visible in CFX. Does any body know about this problem.Kindly Suggest. Regards Kirti

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Turbulence length scale and integral length scale	rizhang	CFX	2	April 22, 2016 08:22
ATTENTION! Reliability problems in CFX 5.7	Joseph	CFX	14	April 20, 2010 16:45
heat generation in CFX	Ema	CFX	4	August 7, 2009 06:39
Electronics Enclosure Analysis with CFX	Simulation Engineer	CFX	1	April 22, 2009 12:08
CFX 10's solutions differ from CFX 5.7's	Atit Koonsrisuk	CFX	4	July 26, 2006 12:59

All times are GMT -4. The time now is 05:53.